Model for 3D printing of signal levers used in mechanical interlocking of type Einheit, common on German and Polish railways. Model allows building a model of a single or a coupled lever (without a transmission disk stopper).
Model does not contain parts of additional equipment, which is available as separate downloads:
Parts are optimized for 3D printing in FFF technique (fused PLA or PETG filament). Recommended basic parameters of the printout:
- layer height: 0.2 mm,
- infill density: 20% (e.g. grid fill pattern),
- selected parts may require printing with additional supports.
The model may require additional drilling patterns available as a separate download.
Based on:
- Album rysunków konstrukcyjnych urządzeń zabezpieczenia ruchu pociągów, vol. 2, Wydawnictwo Komunikacyjne, Warsaw 1961. Scans of the blueprints available at plany.zonk.pl (last access: 11th January 2025);
- Górecki, H.: Podręcznik montera ręcznych i elektromechanicznych urządzeń zabezpieczenia ruchu kolejowego, vol. 1 i 2, WKŁ, Warsaw 1967, 1969;
- Mikulski, A.: Mechaniczne urządzenia zabezpieczenia ruchu kolejowego, WKŁ, Warsaw 1965;
- Mikulski, A.: Mechaniczne urządzenia zabezpieczenia ruchu kolejowego, 4th edition, WKŁ, Warsaw 1979;
- Erläuterungen zu den Einheitszeichnungen für Stellwerksteile (STELL ERL), Deutsche Reichsbahn, F. Ullmann GmbH, Zwickau 1941 (collection by A. Zieliński);
- Einheitszeichnungen für Stellwerksteile, VES, Reichsbahn – Zentralamt, Berlin 1935 – 1943 (collection by P. Mierosławski);
- photos and measurements of interlocking from the collection of Polish Association of Railway Enthusiasts.